 |  |  |  |  |  |
 |  |  |  |  |  |
| Universal Category 1 3 pt Hitch |
| DESIGNED AND MANUFACTURED IN THE USA BY REDLANDHILL. THIS IS A UNIVERSAL 3 POINT HITCH SYSTEM IN CAT 1 SIZING, AND INCLUDES EVERYTHING SHOWN IN THE PICTURES. THIS IS COMPATIBLE WITH ANY CAT 1 3 POINT HITCH IMPLEMENT. IF YOU HAVE AN OLDER TRACTOR THAT DID NOT COME WITH A FACTORY 3 POINT SYSTEM THIS IS WHAT YOU NEED TO PUT IT TO WORK USING ANY OF THE DOZENS OF 3 POINT IMPLEMENTS THAT CAN BE FOUND EVERYWHERE. OPEN CENTER DESIGN, ALLOWING YOUR TRACTORS PTO TO PASS THROUGH THE MIDDLE. IT USES A 2” X 8” DUAL ACTION HYDRAULIC CYLINDER THAT YOU WILL NEED TO PROVIDE YOUR OWN HYDRAULIC LINES FOR HOOKUP. YOU WILL ALSO NEED TO FABRICATE YOUR OWN MOUNTING BRACKETS TO FASTEN IT TO YOUR TRACTOR. LIFTING CAPACITY IS AS SHOWN BELOW AND DEPENDS ON THE HYDRAULIC PRESSURE YOUR TRACTOR PROVIDES, GENERALLY 2500-2740 PSI. THIS SYSTEM PROVIDES DOWN PRESSURE AS WELL AS UP PRESSURE WHICH IS RARELY FOUND ON TRACTOR MANUFACTURERS 3 POINT SYSTEMS. BY REMOVING 1 PIN IT IS CONVERTED TO FLOAT, MEANING YOU WILL HAVE UP PRESSURE, BUT NOT DOWN, WHICH IS EXTREMELY USEFUL WHEN PULLING IMPLEMENTS ON ROUGH TERAIN. IF YOUR TRACTOR DOES NOT HAVE A HYDRAULIC SYSTEM, 12 VOLT HYDRAULIC POWER UNITS ARE AVAILABLE AND CAN USUALLY BE FOUND CHEAP ON EBAY. THOSE SYSTEMS USUALLY PROVIDE 2000 PSI, GIVING YOU A LIFT CAPACITY OF 1178 POUNDS. BY WELDING ON A 2” RECEIVER TUBE THIS WILL MOUNT RIGHT ON THE BACK OF YOUR TRUCK. JUST ATTACH IT TO A 12V HYDRAULIC POWER UNIT. IF YOU WANT THE RECEIVER TUBE LET US KNOW WHEN MAKING PAYMENT AND WE WILL INCLUDE IT WELDED AND BRACED AT NO EXTRA CHARGE. ALL YOU WOULD NEED TO DO THEN IS RUN A 2” SOLID SQUARE STEEL BAR THROUGH IT TO ATTACH TO YOUR TRUCK. THE CYLINDER IS RATED AT A MAXIMUM WORKING PRESSURE OF 3000 PSI. AND HAS BEEN TESTED FOR LEAKS BY THE MANUFACTURER AT 4500 PSI. HYDRAULIC PSI LIFTING CAPACITY 3000 1767 POUNDS 2750 1619 POUNDS 2500 1472 POUNDS 2250 1325 POUNDS 2000 1178 POUNDS LIFT TRAVEL IS 27” FROM LOWEST TO HIGHEST POSITION |
|